Fits Hadley hubs with Shimano Style 10/11 speed freehubs that have 20mm inside diameter freehub ball bearings.

See photo of the gold and red hubs, the gold hub is for this conversion kit where the axle nut flares out at the base of it, where as the red hub the axle nut is a straight cylinder, it would require a different kit.

This retrofit conversion kit uses the 2020 axle and new bearings and spacers to adapt to this new axle.

Will not work with 2020 and newer Shimano Freehubs.

Special Tools Needed to install

Recommend using Hadley 18mm and 15mm open end thin wrenches

or you can use a ParkTool 15mm PW-5 pedal wrench in place of the Hadley 15mm

Kit includes a new bearing pre-load adjustment ring that requires a Hadley 29mm pin spanner wrench or equivalent.

Kit includes a new white plastic freehub ball bearing retainer that requires a Hadley 26mm pin spanner wrench.

Recommend using Hadley Tools to remove existing end caps.

Note: This conversion kit allows you to use a standard Hadley SDH hub on a Boost 148mm x 12mm frame but the hub flanges will not be spaced as far apart as the Hadley Boost dedicated H700148 hubs, so you will not get the same lateral stiffness as the Hadley H700148 hubs.

Re-dishing the wheel may be required since the axle on this adapter kit protrudes out 6mm more on the disc side than the drive side.