[Home [Brakes[Drivetrain]   [Guards/Guides]   [Handlebars/Grips]  [Headsets]  [Hubs] 

 [Protective Gear [Saddles/Seatposts]  [Stems [Suspension] [Tires/Tubes [Tools]


Hadley Thru-Bolt 9mm x 100mm with Nut



Hadley 9mm Front Axle

9mm Thru-Bolt (100mm spacing) + Nut


Clear Anodize Finish

Fits Hadley 9mm Thru-Bolt Front Hubs and any other 9mm x 100mm Thru-Bolt hubs

Uses one 6mm Allen wrench (hex key wrench) to install and remove, nut on right side has tab that fits in fork dropout

to keep from spinning.

Fits most magnesium fork lowers with 6.36mm or thicker dropouts, some 4130 Cr/Mo forks with thinner dropouts

less than 6.36mm will not fit without using a 1.5mm thicker washer Hadley makes, e-mail or call if you have the thinner

fork dropouts.

Hadley Part No: H500258-CLR

$25.00 US Dollars



in Stock

  Out of Stock